Google+ Followers

2016-05-25

A new lift point for the mower.

The hook I made a while back wasn't a real success, its positioning wasn't quite right, so today I had a bit of a think and came up with this simple little thing. It's actually holding the mower in the air in this shot but without bending the panel as the hook I put in the hole on the left did.
I wish I could see when I'm welding but this appears good enough even if a bit lumpy.
Raising the mower with the hoist is great for working on the mower and very handy for when we're flooded.

No comments:

Post a Comment